Pego Schaltkasten elektronisch 230V, ECP Plus R200 Expert m.Datenlogger 3NTC

The scope of delivery includes 1x NTC sensor 10K 1% for evaporator and 1x NTC sensor 10K 1% for temperature display.
Further information can be found in the "Scope of delivery" tab.

ECP 202 Expert (successor model to the ECP 200 Expert) is a microprocessor controlled cooling system controller for regulating room temperature, evaporator fans and defrosting heater. The actual temperature is shown on a three-digital LED display. The cooling system controller features five independent relay outputs for the compressor, evaporator fan, defrosting heater, alarm and room lighting. The ECP 202 Expert cooling system controller also features two isolated input contacts (door contact switch and compressor protection) that can be configured accordingly. The state of each output is shown on the display. The cooling system controller is programmed using the buttons on the front panel. The ECP 202 Expert cooling system controller also features two NTC sensor inputs for reading the room and evaporator temperatures. Sensor breaks and short circuits are shown on the display.

Design:
Complies with generally application standards and regulations, such as:
CE, EN 61000-6-1 EN 61000-6-3 EN 60335 – 1.
In pump down mode, the LP pressure switch is connected to the digital input
(terminal INP-1 and INP-GND). The solenoid is connected to the AUX / Alarm relay. Parameter AU is set to 4.

User note:

• The ECP Plus 202 Expert must be placed into service by trained technicians only.
• Modifications to the device can affect safety.
• Make sure to check type label for power supply information.
• The manufacturer assumes no liability if the equipment has been modified or improperly used.